Measure up 84" from the floor. Use a level to draw
a level line at this height.
Place the rail on the wall so this line is visible through
the mounting holes. Circle each mounting hole along the
level line. No need to align holes with studs.
Drill each mounting hole with a 5/16" drill
bit.
If you do hit a stud, you may use a smaller 5/32"
pilot hole with the screw (no anchor required).
Insert anchors into 5/16" holes. Do not twist or
turn anchors.
Place rail over anchors. Hand-tighten screws.
Using a drill, tighten each screw. IMPORTANT: Allow screw
to turn 6-8 full rotations after it is flush to the
rail so the anchor tightens into a ball behind the
drywall.
